Dyna-Flo Liner Capping StripsStarting @ $40.00
Dyna-Flo® Capping Strips cover the Dyna-Flo Liner along the sidewalls. These 6″ wide x 120″ long, heavy duty capping strips are available in aluminum as well as steel. The capping strips can be welded directly to the end dump’s sidewalls or can be fastened using the Dyna-Flo self tapping screw kit. When installing, leave between 1″ and 1.25″ gap between the top edge of the liner and the top inside of the capping strip.
Dyna-Flo Asphalt Hold Down Plate$195.00
Dyna-Flo® Asphalt Hold Down Plate is factory installed on the underside of the Dyna-Flo Asphalt Liner’s tail end. This hardened steel plate keeps the liner flat on the floor and helps reduce material from working its way underneath the liner. This innovative plate eliminates curling caused by hot material such as asphalt and heated calcined bauxite.
Dyna-Flo End Dump Liner Heat Shield$175.00
Dyna-Flo® End Dump Liner Heat Shield protects the Dyna-Flo Liner from the dump truck’s heated exhaust. The 36″ x 40″ heat shield is installed between the Dyna-Flo Liner and the truck’s high temperature exhaust inlet into the dump body. The heat shield can withstand a direct temperature of 1100° F and radiant temperature of 2000° F.
Dyna-Flo Custom Liner Scoring$75.00
Dyna-Flo® Custom Liner Scoring helps you form our UHMW End Dump Liner Material to your end dump’s dimensions. Just fill out the measurement guide and send it in along with your liner order. Our experienced liner fabicators will score the liner to your supplied dimensions.
Dyna-Flo Stainless Steel Floor Bolt Kit$29.00
Dyna-Flo® Stainless Steel Floor Bolt Kit is packaged exclusively for the installation of our Dyna-Flo UHMW liners. Each kit comes with 15 floor bolts, cupped washers, fender washers, lock washers and locking nut. These bolt assemblies are to be fastened through the liner and the end dump’s floor. They are recommended to be evenly spaced at the front end of the liner. Recommended spacing from the bulkhead and hoist box is 3 to 5 inches.
Dyna-Flo Self-Tapping Floor Bolt Kit$24.50
Dyna-Flo® Self-Tapping Floor Bolt Kit is packaged exclusively for the installation of our Dyna-Flo UHMW liners. Each kit comes with 50 self tapping Torx-Head floor bolts and stainless steel cupped fender washers. These bolt assemblies are to be fastened through the liner and the end dump’s floor They are recommended to be evenly spaced at the front end of the liner. Recommended spacing from the bulkhead and hoist box is 3 to 5 inches.
Dyna-Flo King Pin Plate Poly Lube Disc$32.50
Dyna-Flo® HMW Lube Disk eliminates King Pin Plate grease and Fifth Wheel lubricants. Dyna-Flo® HMW Lube Disk slides over king pin and is attached by the included spring washer.
These 32″ diameter x .170 thick lube disks are easily installed on existing king pin plates.
- About Us
- AERO® Tarp Kits
- Dyna-Flo® Liners
- UHMW Sheet Products
- Industrial Products
- Marine Products
- Parts & Supplies
- Easy Cover Tarp Parts
- Crank N’ Go Tarp Parts
- Conestoga Tarp Parts
- UHMW Plastic Jig Stock
- Dyna-Flo® Liner Parts
- Contact Us